techno mobile
The Tecno Spark 10C is a budget-friendly smartphone that was released in September 2023. It has a 6.6-inch IPS LCD display with a 720 x 1612 pixel resolution and a 90Hz refresh rate. The phone is powered by a Unisoc Tiger T606 octa-core processor and comes with 4GB or 6GB of RAM and 64GB or 128GB of storage.

Some Features of Tecno Spark 10C’s key specs:

  • Display: 6.6-inch IPS LCD display, 720 x 1612 pixel resolution, 90Hz refresh rate
  • Processor: Unisoc Tiger T606 octa-core processor
  • RAM: 4GB or 6GB
  • Storage: 64GB or 128GB
  • Rear camera: 50MP main sensor, 2MP depth sensor
  • Front camera: 16MP
  • Battery: 5000mAh
  • Operating system: Android 12

To flash an SPD CPU, you will need the following:

  • A computer with a Windows operating system
  • The SPD Flash Tool
  • The SPD CPU firmware file
  • A USB cable to connect your device to your computer

Once you have all of the necessary tools and files, you can follow these steps to flash your SPD CPU:

  1. Extract the SPD Flash Tool to a folder on your computer.
  2. Open the SPD Flash Tool folder and run the UpgradeDownload.exe file.
  3. In the SPD Flash Tool, click on the Load Packet button and select the SPD CPU firmware file.
  4. Click on the Download button to start flashing your device.
  5. Connect your device to your computer using the USB cable.
  6. Wait for the flashing process to complete.
  7. Once the flashing process is complete, disconnect your device from your computer and restart it.

If you are flashing your device for the first time, it is important to note that you may need to install the SPD CPU drivers on your computer. You can download the drivers from the SPD Flash Tool website.

Here are some additional tips for flashing an SPD CPU:

  • Make sure that your device is fully charged before you start flashing.
  • Do not disconnect your device from your computer while the flashing process is in progress.
  • If you encounter any problems during the flashing process, try restarting your device and your computer.
  • If you are still having problems, you can search for help online or contact the manufacturer of your device.

Download Techno Spark 10C K15K MDM Remove Firmware / Flash File :

Techno Spark 10C K15K MDM Remove Firmware / Flash File 

TECHNO SPARK _10C_KI5K_ MDM FILE_100%.zip (3.9G)

K15k MDM Remove if Your Device got Hang issue

Join Our Telegram Group. If you have any problems then comment below or message us. We try our best to help you. If you found this post and our site helpful then Dont forget to like and share our page.

Please Follow these Before Flashing :

▶️ Disclaimer: Firmware flashing is not an easy process and should be carried out only if you have enough knowledge. We are not responsible for any damage/ dead to your device.

▶️ Take a Backup: If you are going to flash the above firmware on your Lava device, then make sure to take a backup of your data as it will be deleted after flashing the stock firmware.

▶️ Download and Install the Proper Drivers and Tools required before flashing.

▶️ If You Need Any Other Firmware or Flash File, Let Us Know.

 

Ads Blocker Image Powered by Code Help Pro

Ads Blocker Detected!!!

We have detected that you are using extensions to block ads. Please support us by disabling these ads blocker.

Powered By
100% Free SEO Tools - Tool Kits PRO

You cannot copy content of this page. DCMA Protected.