Download Vivo Vivo Y01 PD2140NF firmware to repair vivo hang on logo , software issue , boot logo , pattern , pin , frp , dead fix repair. You can use any Flash tool to flash this firmware. You can download this Tool For Free. It is Tested Firmware but please use on your own risk.
How to flash MTK Phones?
Flashing a MediaTek (MTK) phone involves installing a new firmware on the device. Here are the general steps to flash an MTK phone:
Note: Flashing firmware can result in data loss or bricking of the device if not done correctly. Make sure to backup your data and follow the steps carefully.
- Download the firmware: Download the correct firmware for your MTK phone from a trusted source. Make sure to download the latest version available and that it is compatible with your device’s model number.
- Install the MTK USB driver: Download and install the MTK USB driver on your computer. This driver is needed to connect your MTK phone to your computer in fastboot mode.
- Download the SP Flash Tool: Download and install the SP Flash Tool on your computer. SP Flash Tool is a utility that allows you to flash firmware on MTK devices.
- Boot your device into fastboot mode: Turn off your MTK phone and boot it into fastboot mode by pressing and holding the Volume Down + Power buttons simultaneously.
- Connect your device to your computer: Connect your MTK phone to your computer using a USB cable. Make sure that your device is recognized by your computer and that the drivers are installed correctly.
- Open the SP Flash Tool: Open the SP Flash Tool software on your computer.
- Add firmware file to SP Flash Tool: Click on the “Scatter-loading” button in SP Flash Tool and select the scatter file from the firmware folder.
- Start the flashing process: Click on the “Download” button in SP Flash Tool to begin the firmware flashing process. Do not disconnect your device during the process, and wait until the flashing process is complete.
- Reboot your device: Once the firmware flashing process is complete, your device will automatically reboot. It may take some time for your device to boot up, so be patient.
That’s it! Your MTK phone should now be running the latest firmware. If you encounter any issues during the flashing process, it’s recommended to seek help from an experienced technician.
This File can fix :
- Hang on logo
- Vivo Dead after flash
- Vivo Dead after removing pattern
- Vivo Dead after removing frp
- White LCD issue
- remove pattern frp
Download Vivo Vivo Y01 PD2140NF Flash File Firmware :
PD2140NF_EX_A_3.4.6_vivo_osc_20220127141552_mtk_alps-release-s0-pre9_sp
PD2140NF_EX_A_3.5.8_vivo_osc_mtk_alps-release-s0-pre9_sp
Important Note :
1. This flashing will erase your personal data , images , contact etc. Please backup before starting flashing.
2. Battery should be charge More than 50% for flashing.
3. Please use correct flash file and correct tools for flashing.
4. This flashing may damage your device too so please do this on your own risk.Note : If you have any problems then comment below or message us. We try our best to help you. If you found this post and our site helpful then Dont forget to like and share our page.
