RAM: 4GB or 6GB
Storage: 64GB or 128GB
Rear Camera: Quad-camera system: 50MP main sensor, 8MP ultrawide sensor, 2MP macro sensor, and 2MP depth sensor
Front Camera: 8MP
Battery: 6000mAh with 18W fast charging
OS: Android 11 with MIUI 12.5 on top
How to Flash Mediatek Firmware :
Flashing MTK (MediaTek) firmware on a device involves using specific tools to update or reinstall the device’s firmware. Here’s a general guide on how to flash MTK firmware:
Requirements:
- Download Necessary Files:
- SP Flash Tool: This is a commonly used tool for flashing MTK devices.
- MTK USB Drivers: Ensure you have the correct USB drivers installed on your computer.
- Stock Firmware: Download the official stock firmware for your specific MTK device.
- Install MTK USB Drivers:
- Before connecting your MTK device to the computer, make sure the MTK USB drivers are installed. If not, download and install them.
- Backup Data:
- Flashing firmware may erase your data. It’s essential to back up your important files and data before proceeding.
- Charge Your Device:
- Ensure your MTK device has sufficient battery charge to avoid any interruptions during the flashing process.
Flashing Process:
- Extract Files:
- Extract the downloaded SP Flash Tool and stock firmware files to a convenient location on your computer.
- Launch SP Flash Tool:
- Open the SP Flash Tool on your computer.
- Load Firmware:
- In the SP Flash Tool, click on “Choose” or “Scatter-loading” and select the scatter file from the firmware folder you extracted earlier.
- Power Off Your Device:
- Turn off your MTK device.
- Connect Your Device:
- Use a USB cable to connect your MTK device to the computer.
- Start Flashing:
- In the SP Flash Tool, click on the “Download” button to begin the flashing process.
- Wait for Completion:
- The tool will now flash the firmware to your MTK device. Wait for the process to complete.
- Complete the Process:
- Once the flashing is done, you should see a success message. You can now disconnect your device and reboot it.
Download Redmi 10 Prime (selene) Global MIUI V12.5.9 Dead Boot Repair Full Dump
Redmi 10 Prime (selene) Global MIUI V12.5.9 Dead Boot Repair Full Dump
Join Our Telegram Group. If you have any problems then comment below or message us. We try our best to help you. If you found this post and our site helpful then Dont forget to like and share our page.
Please Follow these Before Flashing :
▶️ Disclaimer: Firmware flashing is not an easy process and should be carried out only if you have enough knowledge. We are not responsible for any damage/ dead to your device.
▶️ Take a Backup: If you are going to flash the above firmware on your Lava device, then make sure to take a backup of your data as it will be deleted after flashing the stock firmware.
▶️ Download and Install the Proper Drivers and Tools required before flashing.
▶️ If You Need Any Other Firmware or Flash File, Let Us Know.
